The following is the procedures to be followed in
cnc programming and
machining. the most important poin is to verify the programme by test run it on the machine before the actual machining in order to ensure that the programme is free of mistake.
- Study the part drawing carefully.
- Unless the drawing dimension are cnc adapted,select a suitable programme zero point on the work piece. The tool will be adjusted to this zero point during the machine set up.
- Determine the machining operetions and their sequence.
- Determine the methode af work clamping ( jig and fixtures ).
- Select cutting tools and determine spindle speed and feeds.
- Write programme ( translate machining step into programme blocks ).If many solutions are possible, try the simplest solution first. It usually longer, but better to procced in this way.
- Prepare tool chart or diagram, measure tool geometry (lengths,diameter) and note.
- Clamp work piece and set up machine.
- Enter compensation value if necessary.
- Check and test programme. It is good practice to dry run programme.
- without the workpiece
- without the cutting tool
- by raising the tool to safe heigth, If necessary, correct and edit programme and check again.
And than Start machining.
This entry was posted on Senin, 13 Juni 2011
and is filed under March 2011. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response.
